098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 91
Chapter 3
TimeProvider 2300/2700 CLI Command Set
Port config
----------------------------------------------
| Port | State | Io dir | Signal/format|
|--------|---------|----------|--------------|
| t1e1 | enable | output | e1 |
|........|.........|..........|..............|
Example 2:
TP2700> show input status t1e1
Response 2a:
------------------------------------------------------------------------------
|Port |input status|ssm |los |ais |oof |bpv |crc |
|---------|------------|--------|--------|--------|--------|--------|--------|
|t1 input |fault |na |fault |ok |ok |ok |na |
------------------------------------------------------------------------------
Response 2b:
Status: Input port is disabled
Response 2c:
Status: Port is configured as output
Remarks:
– Line code, SSMBIT and CRC do not apply to freq2048khz, and
freq1544khz.
– CRC for T1 input is not user-configurable. It is always ENABLE for ESF,
and does not apply for D4.
– SSMBIT only applies to E1 frame signal CCS or CAS.
– Use the "show ref" command to display SSM state information.
Level : User, Config, and Admin
set input
When the T1/E1 port is configured as an input port, use this command to provision
all other configurable parameters for the input signal on the T1/E1 port:
Framing Type
To Next Page
Loading...
Need help?
General