EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #248 background imageLoading...
Page #248 background image
248 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 4 Provisioning
Testing TP 2300/2700 Provisioning
2. Type show output status t1e1 and press Enter.
Verify that the IO Status shows the desired signal format and “output”.
Verify that the Port Status is “on”.
------------------------------------
| Port | io status | port status |
|------|-----------|---------------|
| t1e1 | e1 output | on |
|..................................|
Verifying TOD Functionality
1. Type show port-control and press Enter.
Verify that the State for the TOD port is “enable”.
Verify that the Signal/Format is the desired type.
--------------------------------------------
|# |Port |State |IO dir |Signal/Format|
|---|-------|--------|-------|-------------|
|1 |t1e1 |enable |output |t1 |
|...|.......|........|.......|.............|
|2 |pps10m |enable |output |10MHz |
|...|.......|........|.......|.............|
|3 |tod |enable |output |cisco |
--------------------------------------------
2. Type show output status tod and press Enter.
Verify that the State for the TOD port is “enable”.
Verify that the Signal/Format is the desired type.
TOD CISCO output message
*,A,56415,13/05/02,03:52:17,000.0,0,37N22.716,121W55.581,+00
14
or
TOD China Mobile output message

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish