EasyManuals Logo

Symmetricom TimeProvider 2700 User Manual

Symmetricom TimeProvider 2700
338 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #182 background imageLoading...
Page #182 background image
182 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 4 Provisioning
Establishing a Connection to the TimeProvider 2300/2700
Establishing a Connection to the TimeProvider 2300/2700
To set up and manage the TimeProvider 2300/2700 with a terminal or a computer
with terminal emulation, you must establish either a serial connection or an Ethernet
connection. To connect through the serial port, see Communicating Through the
Serial Port, on page 182. If the TimeProvider 2300/2700 is connected to an Ethernet
LAN, use the procedure described in Communicating Through the Ethernet Port, on
page 182.
Communicating Through the Serial Port
An EIA-232 serial port is available on the front panel for a direct serial connection to
a terminal or a computer with terminal emulation. Use the following procedure to
connect the TimeProvider 2300/2700 to a terminal or a computer with terminal
emulation via a straight through serial cable:
1. Connect one end of a straight through serial cable to the serial port on the
computer or terminal and the other end to the EIA-232 connector on the TP
2300/2700.
2. Configure the emulation software for 8 data bits, 1 stop bit, no parity, 57600 baud
rate, and no flow control.
3. Start the terminal emulation software and press Enter. The system prompt
should appear. If it does not, recheck each step in this procedure.
4. Type your user name and press Enter. The system prompts for a password.
5. Type your password and press Enter. The system prompt appears.
Communicating Through the Ethernet Port
To communicate with the TimeProvider 2300/2700 using an Ethernet LAN
connection, you must first configure the Ethernet port through the EIA-232 serial
port.
Note: For information on restricting user access, see Managing the
User Access List, on page 184.
Note: The default user name is “admin”. The default password is:
symmadmin**.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom TimeProvider 2700 and is the answer not in the manual?

Symmetricom TimeProvider 2700 Specifications

General IconGeneral
BrandSymmetricom
ModelTimeProvider 2700
CategoryNetwork Hardware
LanguageEnglish