098-00564-000 Revision A3 – July, 2013 TimeProvider 2300/2700 User’s Guide 183
Chapter 4 Provisioning
Establishing a Connection to the TimeProvider 2300/2700
Configuring the Ethernet Port
Use the following procedures to configure the TimeProvider 2300/2700 Ethernet
parameters (IP Address, Subnet Mask, and Gateway Address).
1. Establish a direct serial connection to the TimeProvider 2300/2700 as described
in Communicating Through the Serial Port, on page 182.
2. Provision the IP, Gateway, and Subnet Mask addresses for the TimeProvider
2300/2700. The IT department or site administrator for your location can
recommend specific addresses for these parameters. Use the dotted decimal
format xxx.xxx.xxx.xxx to enter the address parameters with the following
commands:
Example 1
ï€
Using Static IP:
TP 2700> set ip address-mode mgmt ipv4 static
TP 2700> set ip ip-address mgmt ipv4 address 192.168.0.10 netmask
255.255.255.0 gateway 192.168.0.254
TP 2700> set ip state mgmt ipv4 restart
Example 2
ï€
Using DHCP:
TP 2700> set ip address-mode mgmt ipv4 dhcp
TP 2700> set ip state mgmt ipv4 restart
Connecting Through an Ethernet LAN
1. Ensure that the TimeProvider 2300/2700 is connected to a LAN (see
Communications Connections, on page 50 for details).
2. Telnet from your computer to the IP address assigned to the TimeProvider
2300/2700 (see Configuring the Ethernet Port, on page 183).
Note: The TimeProvider 2300/2700 default IP address is
192.168.0.100, the subnet mask is 255.255.255.0, and the gateway
address is 0.0.0.0 (no gateway). If these defaults are acceptable, the
following procedure using the serial port is not required.
Note: The telnet firewall is set to Block by default. Use the following
command to set the firewall to Allow for telnet communications:
set firewall mgmt telnet allow
To Next Page
Loading...
Need help?
General