144 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
Table 3-5. PTP Client
ï€
Parameter Descriptions for Telecom-2008 Profile
Parameter Description
transport Network (PTP packet delivery): Ethernet
service-tier PTP sync service tier applies to PTP client and is defined
by a performance mask which is used to monitor
performance.
asymmetry Use to enable or disable compensation for network path
asymmetry between PTP client input port and master. Also
use to clear asymmetry information.
ptp-state Use to enable or disable PTP functionality for the specified
port.
ttl Use to set the IP header Time-to-Live value This field is
used to limit how many hops a packet will be transmitted in
a network.
announce-interval Used on client port to negotiate with master the announce
message rate. This parameter is applicable to Unicast
profiles only.
The interval is 2
z
seconds, where z=
<announce-limit-value>.
sync-interval Used on client port to negotiate with master the Sync
message rate. This parameter is applicable to Unicast
profiles only.
The interval is 2
z
seconds, where z= <sync-limit-value>.
delay-req-interval Used on client port to negotiate with master the
delay-request message rate. This parameter is applicable
to Unicast profiles only.
The interval is 2
z
seconds, where z= <delay-limit-value>.
announce-receipt-timeout The announce-receipt-timeout specifies the announce
interval that has to pass without receipt of an announce
message before the occurrence of this event. If this event
happens on the client port, the client port will switch to the
backup Master.
unicast-negotiation Use to enable or disable the client’s ability to negotiate with
Grandmasters for service in Unicast profiles.
lease-limit Sets the PTP lease limit of service with the master. This
parameter is applicable to client port while running Unicast
profiles.
To Next Page
Loading...
Need help?
General