112 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
SSM Bit position for E1
Zero-Suppression (On or Off) for E1
All the configurations provisioned by this command apply to the T1/E1 port only
when the IO-direction of the port is configured as an Output with the
set
port-control t1e1 io output
command.
The provisioning displayed with the
show output config t1e1 command will
apply to the T1/E1 port only when the IO-direction of the port is configured as
OUTPUT with the
set port-control t1e1 io output command.
Command Syntax:
To provision the output frame type for an E1 output signal:
set output e1 frametype t1e1 {ccs | cas | freq2048khz}
To provision CRC for an E1 output signal:
set output e1 crc t1e1 {enable | disable}
To provision the output SSM Bit for an E1 output signal:
set output e1 ssmbit t1e1 {4 | 5 | 6 | 7 | 8 | all }
To provision zero-suppression for an E1 output signal:
set output e1 zero-suppression t1e1 {on | off}
To provision the output frame type for a T1 output signal:
set output t1 frametype t1e1 {d4 | esf | freq1544khz |
isolateOne}
To provision the 1PPS time offset on the PPS/10M output port:
set output pps offset pps10m <offset-value>
Example 1:
To set the frame type to 2048 kHz for E1 output on the T1/E1 port:
TP2700> set output e1 frametype t1e1 freq2048khz
Example 2:
To Enable CRC for E1 output on T1/E1 port:
TP2700> set output e1 crc t1e1 enable
Example 3:
To provision the SSM Bit position to 6 for E1 output on T1/E1 port:
To Next Page
Loading...
Need help?
General