Symmetricom TimeProvider 2700 User Manual

208 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 4 Provisioning
Provisioning Input Parameters
1. Login at the Admin or Config-user level (see Logging In, on page 185).
2. Type
set gnss posmode auto and press Enter.
3. Type
set gnss track-mode gps and press Enter.
4. Type
set gnss cable-delay 315 and press Enter.
5. Type
set gnss state enable and press Enter.
6. Type
show gnss status and press Enter to verify that GNSS is enabled.

Symmetricom TimeProvider 2700 Specifications

General

Brand	Symmetricom
Model	TimeProvider 2700
Category	Network Hardware
Language	English