Symmetricom TimeProvider 2700 User Manual

288 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Appendix A System Messages
System Notification Messages
071
PTP server exceeded # percent
of client limit on ETH2
22=ETH2
072
PTP client xx:xx:xx:xx:xx:xx:xx:xx
dropped from ETH2 client list
22=ETH2
073
PTP client xx:xx:xx:xx:xx:xx:xx:xx
added from ETH2 client list
22=ETH2
074
PTP client list on ETH2 refreshed
22=ETH2
075
PTP state changed to disabled
22=ETH2
076
PTP state changed to listening
22=ETH2
077
PTP state changed to master
22=ETH2
078 PTP state changed to passive
22=ETH2
091
GNSS receiver communications
failed
00=GNSS
092
GNSS receiver not tracking satellite
0 0=gnss
093
GNSS signal low
0 0=gnss
094
GNSS antenna voltage out of range
(#)
0 0=gnss
095
GNSS antenna current out of range
(#)
0 0=gnss
096
GNSS antenna short-circuit
0 0=gnss
097
GNSS antenna open-circuit
0 0=gnss
111
Management port link down link down
0-2 0=mgmt
1=eth1
2=eth2
112
Excessive traffic on port ETH{1|2}
1-2 1=eth1, 2=eth2
113
Unsupported SFP on ETH{1|2}
1-2 1=eth1, 2=eth2
131
Power out of range
0-3, 6-7
0=+1.2v,
1= - 5.0
2=+2.5v,
3=+3.3v,
6=+1.5V
7= + 5.0V(ocxo)
132
Operational failure: 1PPS interrupt
00-=1pps
Table A-2. Secondary Index Descriptions for System Notification Messages
Event
ID
Description
Secondary
Index
Secondary Index
Description

Symmetricom TimeProvider 2700 Specifications

General

Brand	Symmetricom
Model	TimeProvider 2700
Category	Network Hardware
Language	English