Symmetricom TimeProvider 2700 User Manual

74 TimeProvider 2300/2700 User’s Guide 098-00564-000 Revision A3 – July, 2013
Chapter 3
TimeProvider 2300/2700 CLI Command Set
set clock date-time <date-time>
Enter date and time in YYYY-MM-DD,HH:MM:SS format (UTC)
 To set the Accumulated leapseconds:
set clock leapseconds <value>
Example 1:
To set date to June 09 2013, and time to 10:35 PM and 24 sec.(UTC):
TP2700> set clock date-time 2013-06-09,22:35:24
Example 2:
To set the accumulated leapseconds to 29 seconds:
TP2700> set clock leapseconds 29
Level : Config and Admin
Note: If your GNSS is in GLONASS tracking mode, this command
also provides the user-provisioned leap second to GPS-GLONASS.

Symmetricom TimeProvider 2700 Specifications

General

Brand	Symmetricom
Model	TimeProvider 2700
Category	Network Hardware
Language	English