Telecor VS1 - Routing Calls from a Specific Area Code

VS1 Installation, Configuration & Operating Guide 115
Start Time and End Time: Set a time frame for the Caller ID number you specified. Times
must be entered in standard 24-hour (military) format. If you want a call routed anytime, type
00:00 in the Start Time text box and type 24:00 in the End Time text box.
Note The End Time must not come before the Start Time.
Days Enabled: Check the day(s) of the week that the incoming number will be routed.
Target Extension: Enter the extension that you want the incoming call routed to. You can only
type one extension. You can target an incoming call to a Work Group extension. By doing this,
all phones in the specified Work Group ring and display the specified description.
4. Click the Save button in the toolbar.
• The CID Routing entry is added to the list box above.
5. Repeat steps 2-4 for other CID Routing entries.
To edit a Caller ID Routing Entry, select it from the list box and make the required edits.
To delete a Caller ID Routing Entry, select it from the list box and click Del. A dialog box appears
asking you to confirm your deletion. Click Yes and your entry is deleted.
Routing Calls from a Specific Area Code
Caller ID Routing can be set up to transfer incoming calls from a specific area code to a preassigned
extension. Complete the following steps:
1. Select CID Routing from the Tree Control display.
• The CID Routing pane appears.
2. In the CID Number text box type in the area code followed by the wildcard x.
3. Fill in the Description, Start Time, End Time, Days, and Target Extension boxes.