Telecor VS1 - Host Adapter Cards Checklist

VS1 Installation, Configuration & Operating Guide 37
Host Adapter Cards Checklist
 Set the port switches on the Host Adapter Card.
 Disconnect CO lines from the PEU, turn off the system, and then remove the TVS cover.
 Locate an available ISA slot, and then remove its slot cover.
 Install the Host Adapter Card in the TVS.
 Connect the Host Adapter Card to the PCM Bus cable in the TVS.
 Replace the TVS cover and reconnect the Host Adapter cable. Plug in and turn on the
system, and then reconnect CO lines to the PEU.
 Connect additional PEUs to the TVS.