VS1 Installation, Configuration & Operating Guide 251
DID Routing pane
T1 Interface Card Diagnostics
The t1 stat command can be issued from the TVS Command prompt in Terminal window of
Tel-Site or from the TVS Command prompt. This command provides a status screen displaying
diagnostic information for the specified T1 Interface Card. Refer to the screen below.
• Issue the t1 stat 0 command to display information on the first T1 Interface Card.
• Issue the t1 stat 1 command to display information on the second T1 Interface Card.
Warning! Do not issue the t1 stat command on both the TVS and in the Terminal window of
Tel-Site at the same time or the VS1 phone system will stop working.
T1 Status screen
To Next Page
Loading...