124 VS1 Editor Configuration Application
interface 0 corresponds to ports 97 through 128. If two T1 Interface Cards are installed, interface 0
corresponds to ports 65 through 96 and interface 1 corresponds to ports 97 through 128.
t1 stat {0|1}—Displays the current status of the specified T1 Interface Card. This
information can be useful in T1 troubleshooting. If one T1 Interface Card is installed, interface 0
corresponds to ports 97 through 128. If two T1 Interface Cards are installed, interface 0 corresponds
to ports 65 through 96 and interface 1 corresponds to ports 97 through 128. See “T1 Interface Card
Diagnostics” in Reference section for more information.
time—Displays the current system time. See date command.
vec load {file name}—Reserved for Telecor Technical Support use. Do not change this
setting.
vec dtmf {0|1}—Reserved for Telecor Technical Support use. Do not change this setting.
vm {extension}—Allows editing of the Voice Mail passcode and Pager Notification settings
for the specified extension.
vmaint purge {extension|*} {daysold} [forward to]—Deletes all Voice Mail
messages older then the number of days specified for the extension specified. Use the wildcard * in
place of the extension to check every Voice Mail Box on the system. For example, vmaint
purge * 90 would delete every Voice Mail message on the system more than 90 days old.
Optionally, the messages can be forwarded to Voice Mail by specifying a forward to extension.
vmaint scan [forward to]—Deletes Voice Mail messages that do not belong to any Voice
Mail extension (such as orphaned messages). Optionally, the messages can be forwarded to another
Voice Mail by specifying a forward to extension.
To Next Page
Loading...