EasyManua.ls Logo

Telecor VS1 - Page 172

Telecor VS1
281 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
VS1 Installation, Configuration & Operating Guide 161
Init String: The default modem initialization string in the Init text box is as follows:
ATB0EDMOX4&C1SO=1. This setting requires adjustment if you replace the modem with one
not supplied by Telecor. Compare the commands of the Telecor modem initialization string and the
modem you want to use, and then adjust the Init String text box accordingly.
Dial Tone: The Dial Tone is set to Internal by default. The sound of the internal dial tone is heard
when a phone user goes off-hook. If the Dial Tone is changed to External, it changes the sound of
the dial tone – not the dialing process.
Polling: For Telecor Technical Support use only.
Page Alert Tone: Page Alert Tone determines which tone is played when a Paging Zone is
activated. Paging Alert Tone is set to Short tone by default. Choose from None, Short tone, Long
tone, or Two tones.
Page Alert Volume: Page Alert Volume is set to Loud by default. Choose either Loud or Soft Page
Alert Volume.
Monitor Password: Select a five-digit password that extensions with Executive Privilege must
enter to begin monitoring an extension.
Monitor Time: A beep tone is heard by all monitored parties every {n} seconds set in this text box.
Ten seconds is the shortest interval between beep tones and 15 seconds is the longest interval
permitted. Any value entered less than 10 results in a 10 second interval, while any value greater
than 15 results in a 15 second interval between beep tones.
Note By default, the beep tone cannot be disabled. However, under special circumstances the
beep tone can be disabled with an activation key. Contact Telecor Technical Support
for authorization requirements to obtain this activation key.
Note To enable the Executive Privilege feature on the TVS you must edit the pbx line of the
startpbx.bat file located in c:\ops to read pbx -e1. To disable the Executive
Privilege feature after you have enabled it, edit the pbx line to read pbx -e0. The default
setting for the Executive Privilege feature is off.

Table of Contents