TOMATECH AUTOMATION
2.1.4 Axis enable signal nEN........................................................................................ 311
2.1.5 Pulse disable signal nSET................................................................................... 311
2.1.6 Zero signal nPC................................................................................................... 311
2.1.7 Connection to a drive unit ................................................................................... 313
2.2 Being Connected with Spindle Encoder..................................................................314
2.2.1 Spindle encoder interface definition.................................................................... 314
2.2.2 Signal explanation .............................................................................................. 314
2.2.3 Being connected with spindle encoder interface................................................. 314
2.3 Being Connected with MPG (Manual Pulse Generator).........................................315
2.3.1 MPG interface definition .................................................................................... 315
2.3.2 Signal explanation ............................................................................................. 315
2.4 Spindle Interface....................................................................................................316
2.4.1 Spindle interface definition................................................................................. 316
2.4.2 Connection to inverter ....................................................................................... 317
2.5TAC-1002T／TAC-100XT-V being Connected with
PC .............................................317
2.5.1 Communication interface definition .................................................................. 317
2.5.2 Communication interface connection................................................................ 317
2.6 Power Interface Connection .................................................................................318
2.7 I/O Interface Definition .........................................................................................318
2.7.1 Input signal ....................................................................................................... 320
2.7.2 Output signal .................................................................................................... 321
2.8 I/O Function and Connection ...............................................................................323
2.8.1 Stroke limit and emergency stop....................................................................... 323
2.8.2 Tool change control ........................................................................................ 325
2.8.3 Machine zero return........................................................................................ 332
2.8.4 Spindle control ............................................................................................... 338
2.8.5 Spindle switching volume control................................................................... 341
2.8.6 Spindle automatic gearing control................................................................. 342
2.8.7 Spindle eight-point orientation function......................................................... 343
2.8.8 Spindle Cs axis control function.................................................................... 347
2.8.9 Multiple spindle function .............................................................................. 350
2.8.10 Rigid tapping function ............................................................................... 354
2.8.11 External cycle start and feed hold............................................................. 355
2.8.12 Cooling control.......................................................................................... 356
2.8.13 Lubricating control .................................................................................... 356
2.8.14 Chuck control............................................................................................. 358
2.8.15 Tailstock control ........................................................................................ 360
2.8.16 Low pressure detection.............................................................................. 361
2.8.17 Hydraulic control (only applied to 980TDc-V) ........................................... 362
2.8.18 Safety door detection................................................................................. 363
2.8.19 CNC macro variables................................................................................ 363
2.8.20 External override ...................................................................................... 364
2.8.21 External MPG............................................................................................ 364
To Next Page
Loading...