TOMATECH TAC-100XT - Parameter Setting; State Parameter

TOMATECH AUTOMATION
0 1
1 0
Chapter 10 Data Setting, Backup and Restore
275
Ⅱ Operation
Bit parameter No.175
Bit1 Bit0
Graphic path coordinate display
1 1
10.4 Parameter Setting
Parameter setting can adjust related characteristics of the drive unit and machine.
Press to enter Parameter interface which includes , , ,
as follows:
10.4.1 State parameter
1) Byte alteration:
a) Turn on the parameter switch;
b) Enter the MDI mode;
c) Move the cursor to the parameter number to be set:
276
Ⅱ Operation
Method 1: Press or to enter the page containing the parameter to be set, press
or key to move the cursor to the parameter number to be set;
Method 2: Press (or ) , and input the parameter number in the
pop-up dialogue box, at last, press .
4) Key in a new parameter value;
5) Press key, the parameter value is entered and displayed.
6) For security, the PARM SWT needs to be set to OFF after all parameter settings are
finished.
Example:
Set the bit parameter No.001 Bit 3(STEP/MPG) to 1, and the other bits remain
unchanged.
Move the cursor to No.001, input 00011000 by sequence according to the above steps.
The
display is shown below:
Press to finish the parameter alteration. The page is shown below:
Chapter 10 Data Setting, Backup and Restore
277
Ⅱ Operation
2) Alteration by bit:
a) Turn on the parameter switch;
b) Enter the MDI mode;