TOMATECH AUTOMATION
3.2 Parameter Description (by function sequence)
3.2.1 X, Z, Y, 4th,5th axis control logic
0 0 1 *** *** *** ISC
Bit1 1: IS-C incremental system；
0: IS-B incremental system.
ISC Least input increment, least command increment Abbreviation
0 0.001mm,0.0001inch IS-B
1 0.0001mm,0.00001inch IS-C
0 0 5 PCMD
PCMD =1: CNC output wave is pulse
=0: CNC output wave is square
0 0 8 DIR5 DIR4 DIRY DIRZ DIRX
Bit4 1: Direction signal (DIR) is HIGH when 5th positively moves ；
0: Direction signal (DIR) is HIGH when 5th negatively moves.
Bit3 1: Direction signal (DIR) is HIGH when 4th positively moves；
0: Direction signal (DIR) is HIGH when 4th negatively moves.
Bit2 1: Direction signal (DIR) is HIGH when Y positively moves ；
0: Direction signal (DIR) is HIGH when Y negatively moves.
Bit1 1: Direction signal (DIR) is HIGH when Z positively moves；
0: Direction signal (DIR) is HIGH when Z negatively moves.
Bit0 1: Direction signal (DIR) is HIGH when X positively moves；
0: Direction signal (DIR) is HIGH when X negatively moves.
If machine moving direction is inconsistent with the actually required direction, it
may be
adjusted by this parameter.
0 0 9 5ALM 4ALM YALM ZALM XALM
Bit4 1: 5th alarm signal (ALM5) is LOW alarm;
0: 5th alarm signal (ALM5) is HIGH alarm.
Bit3 1: 4th alarm signal (ALM4) is LOW alarm;
0: 4th alarm signal (ALM4) is HIGH alarm.
Bit2 1: Y alarm signal (ALMY) is LOW alarm;
0: Y alarm signal (ALMY) is HIGH alarm.
Bit1 1: Z alarm signal (ZALM) is LOW alarm;
0: Z alarm signal (ZALM) is HIGH alarm.
398
Volume Ⅲ Connection
Bit0 1: X alarm signal (XALM) is LOW alarm;
0: X alarm signal (XALM) is HIGH alarm.
This parameter may be adjusted based on the drive unit alarm signal level output.
1 7 5 SPFD
SPFD =1: Feeding stops if spindle stops in cutting
=0: Feeding not stop if spindle stops in cutting
To Next Page
Loading...