TOMATECH TAC-100XT - Pitch Error Compensation Number; Pitch Error Compensation Interval; Offset Value

TOMATECH AUTOMATION
6.3.2 Pitch error compensation number
Set the maximum pitch error compensation number and the minimum pitch error
compensation
number of each axis through parameters No.096 and No.097 so that the compensation
range can be
determined. In an offset value list, the number that corresponds to machine zero point is
called pitch
error compensation origin (reference point). The pitch error compensation origin is set by
parameter
No. 098. It can be any value within the compensation range according to mechanical
requirement.
Data parameter
0 9 6 PECMINn
The maximum pitch error compensation number
0 9 7 PECMAXn
The minimum pitch error compensation number
0 9 8 PECORGn
The pitch error compensation number that corresponds to machine zero point
Chapter 6 Memorizing Pitch Error
447
Ⅲ Connection
6.3.3 Pitch error compensation interval
0 9 9 PECINTn
［Meaning］ Interval between pitch error compensation point
［Unit］
Setting Unit IS-B IS-C
Metric machine 0.001 mm 0.0001 mm
Inch machine 0.0001 inch 0.00001 inch
［Range］
IS-B IS-C
Metric machine 1000～999999 10000～9999999
Inch machine 400～999999 4000～9999999
6.3.4 Offset value
Pitch error offset amount of each axis is set according to the following table, and offset
amount is
input in diameter value without relating to diameter programming or radius programming,
and the
input value unit is the least input increment.
Offset No. Offset value Z Offset value
000 0 0200 0
001 5 0201 -2
002 -3 0202 4
… … … …
… … … …