TOMATECH AUTOMATION
3.1.2 Omitting words
To simplify the programming, their command values are reserved after executing words in
Table 3-2. If the words are contained in the previous blocks, they cannot be input when
the words are used with the same values and definitions in the following blocks.
Table 3-2
Note 1: For the command addresses with functions (such as F, used for feedrate per minute,
feedrate per revolution and metric pitch and so on), they can be omitted not to input when
executing the same function to definite words after the words are executed. For example, after
executing G98 F_ without
executing the thread command, the pitch must be input with F word when machining metric
thread.
Note 2: They can be omitted not to input when the address characters X(U) , Z(W) are the
coordinates of end
point of block and the system defaults the current absolute coordinates in X or Z direction to the
coordinate value of end point of block.
Note 3: The corresponding words must be input when the command addresses which are not in
Table 3-2 are used.
To Next Page
Loading...
Need help?
General