TOMATECH TAC-100XT User Manual

TOMATECH AUTOMATION
bidirectional communication of CNC to CNC, or CNC to PC can also be done.
To prevent the program to be altered or deleted accidentally, a program switch is set up
for this
TAC-100XT system. And it must be turned on before program editing. Please see details
in Section
10.1.1 of the part.
The system provides multi-level user permission to facilitate the management. More than
4 levels
(4 level, 3 level) can open the program switch to edit programs. See OPERATION,
Section 10.1.2 .
6.1 Program Creation
6.1.1 Creating a block number
In the program, a block number can be added or not, the program is executed by the
sequence.
When the “AUTO SEG” switch in SWITCH SETTING window is OFF, CNC doesn’t
generate the block
number automatically, but the blocks may be numbered manually.
When the “AUTO SEG” switch in SWITCH SETTING window is ON, CNC generates the
block
number automatically, it automatically generates the next block number by pressing or
in editing. The block number increment is set by the CNC data parameter No.042. (See
details in
Section 10.1.1 of this part.)
6.1.2 Inputting a program
Press to enter the Edit mode. Press to enter the Program interface, create a
machining program before inputting a machining program. The creating method is shown
below:
Method 1:
224
Ⅱ Operation
1） Press address key , number key , , and key by sequence (e.g.
taking an example of creating program O0001, the leading 0 can be omitted when its
name is
input). Its display is shown below:
2） Press ( or ) to create the new program. The display is shown below:
Method 2:
1) Pres （continuously press it twice when other page is displayed） to enter the local
directory page. The display is shown below:
Chapter 6 Program Edit and Management
225

TOMATECH TAC-100XT Specifications

General

Brand	TOMATECH
Model	TAC-100XT
Category	Control Systems
Language	English