TOMATECH AUTOMATION
parameter, functional command and network in the current displayed block, and move the
cursor to the corresponding position.
（3）Press , to locate the cursor to the home or end of the current block.
3) PLC data page
PLC data includes K, D, DT, DC, which can be set in the page.
204
Ⅱ Operation
4) File list page
The ladder file list page displays all ladders and their relevant information included in the
current
system, and the new ladder can run in the page. The program name marked with is the
current
running ladder.
Note: The file list page is displayed when the above 2-level privilege is executed.
Chapter 2 Power ON/OFF And Protection
205
Ⅱ Operation
CHAPTER 2 POWER ON/OFF AND PROTECTION
2.1 System Power-on
BeforeTAC-1002T power on, the following items should be confirmed:
1. The machine is in a normal state.
2. The power voltage conforms to the requirement of the machine.
3. The connection is correct and secure.
The following window is displayed afterTAC-1002T is turned on:
The current position (ABSOLUTE POS) page is displayed afterTAC-1002T automatic
detection
and initiation are finished.
2.2 System Power-off
Before power is off, ensure that:
1. The feed axes of the CNC is at stop;
2. Miscellaneous functions (spindle, cooling etc.) are OFF;
3. Cut off CNC power prior to machine power cutting off.
Note: Please refer to the machine manufacturer’s manual about turn-off the machine’s power
supply.
206
Ⅱ Operation
2.3 Overtravel Protection
Overtravel protection should be used to prevent machine from being damaged due to the
To Next Page
Loading...
Need help?
General