TOMATECH TAC-100XT - Tool Compensation; Tool Life Management Function; Tool Wear Parameter; Edit and Display

TOMATECH AUTOMATION
［Data unit］ r/min
［Data range］ 1～8000
3.2.8 Tool compensation
0 0 2 NRC
Bit1 1: Tool nose radius offset active
0: Tool nose radius offset inactive
0 0 3 TCOMP
Bit4 1: Tool offset by coordinate offset
0: Tool offset by move
0 0 4 ORC PROD
ORC 1: Tool offset by radius
0: Tool offset by diameter
PROD 1: Programming position for RELATIVE display
0: Position involving offset for RELATIVE display
0 1 2 DOFSI
DOFSI 1: Trial tool setting active
0: Trial tool setting inactive
3.2.9 Tool life management function
0 0 2 *** *** LIFJ MDITL LIFC TLIF
LIFJ 1: Tool life management group skip active
0: Tool life management group skip inactive
MDITL 1: Tool life management active in MDI mode
0: Tool life management inactive in MDI mode
LIFC 1: Tool life counting type 2, by times
0: Tool life counting type 1, by times
TLIF 1: Tool life management active
0: Tool life management inactive
3.2.10 Tool wear parameter
1 4 0 TWEAR_MAX
［Data meaning］ positive/negative limit of tool wear value in tool offset & wear window.
［Data unit］
Set unit IS-B IS-C
Metric input 0.001 mm 0.0001 mm
Inch input 0.0001 inch 0.00001 inch
［Data range］
IS-B IS-C
Metric input 1～99999 1～999999
410
Volume Ⅲ Connection
Inch input 1～99999 1～999999
3.2.11 Edit and display
0 0 5 M30
M30 1: Cursor to beginning after M30