TOMATECH TAC-100XT - Input and Output Function in Metric and Inch System; Parameters Related to Arc Turning; Parameters Related to the Additional

TOMATECH AUTOMATION
［Data meaning］ X（AUTO_OFFSET_Y_X）,Z（AUTO_OFFSET_Y_Z）γ value in
automatic tool
offset.
［Data unit］
Set unit IS-B IS-C
Metric machine 0.001 mm 0.0001 mm
Inch machine 0.0001 inch 0.00001 inch
［Data range］ 1～9999999
Note: X setting value is the radius in diameter programming and radius programming.
1 4 4 AUTO_OFFSET_E_X
1 4 5 AUTO_OFFSET_E_Z
［Data meaning］ AUTO_OFFSET_E_X（X）,AUTO_OFFSET_E_Z（Z）ε value in
automatic tool
offset.
Note: The function needs the automatic tool setting device.
3.2.17 Input and output function in metric and inch system
0 0 1 *** *** INI
INI 1: Inch input
0: Metric input
0 0 3 *** *** *** *** *** OIM
OIM 1: Offset automatically change in metric and inch conversion
0: Offset not change in metric and inch conversion
0 0 4 *** SCW
SCW 1: Inch system for min. code unit, active after repowering
0: Metric system for min. code unit, active after repowering
3.2.18 Parameters related to arc turning
1 5 4 RADIUS_ERR_RANGE
［Data meaning］ max. value of arc radius error.
［Data unit］
Setting unit IS-B IS-C
Metric machine 0.001 mm 0.0001 mm
Chapter 3 Parameters
413
Volume Ⅲ Connection
Inch machine 0.0001 inch 0.00001 inch
［Data range］
IS-B IS-C
Metric machine 0～1000 0～10000
Inch machine 0～50 0～500
3.2.19 Parameters related to the additional
1 8 7 IS1 IS0 RCS *** *** *** ROS ROT
[Data type]: Bit axis
BIT7,BIT6: set incremental system of each axis，00: consistent with the incremental
system of the