TOMATECH TAC-100XT - F Address(CNC→PLC)

TOMATECH AUTOMATION
INPUT
OUTPUT
DATA
PROGRAM
CHANGE OFFSET DIAGNOSIS
ALARM GRAPH
DELETE CANCEL
INSERT
ALTER EOB
GEAR TOOLNO.
MDI MACHINE
ZERO
PROGRAM
ZERO
MACHINE
LOCK M.S.T.LOCK OPTIONAL
STOP
CHUCK COOLING S.CW S.OVERRIDE CYCLE START
RAPID
HYDRAULIC T.CHANGE
F.OVERRIDE
S.CCW S.OVERRIDE F.OVERRIDE
TAILSTOCK LUBRICATING S.STOP ORIENTATION F.OVERRIDE
FEED START
PARAMETER
POSITION SETTING
TAC-100XT-V machine panel
Chapter 5 Diagnosis Message
431
Ⅲ Connection
5.2.4 F address(CNC→PLC)
F0000 OP SA STL SPL *** *** *** RWD
OP: Auto run signal
SA: Servo ready signal
STL: Cycle start indicator signal
SPL: Feed hold indicator signal
F0001 MA *** TAP ENB DEN *** RST AL
MA: CNC ready signal
TAP: Tapping signal
ENB: Spindle enable signal
DEN: Designation end signal
RST: Reset signal
AL: Alarm signal
F0002 MDRN CUT *** SRNMV THRD CSS RPDO INCH