TOMATECH AUTOMATION
■ Troubleshooting
� Switch off power supply before troubleshooting or changing components.
� Troubleshoot and then startup the system when there is short circuit or overload.
� Do not switch on or off it frequently and an interval is 1 minute at least after the system
is powered on again.
All specification and designs are subject to change without further notice.
Warning！
� Please read this user manual and a manual from machine builder
completely before installation, programming and operation; do operate the
system and machine according to user manuals, otherwise it may damage the
system, machine, workpiece and even injure the operator.
Cautions！
� Functions, technical indexes described in this user manual are only for the
system. Actual functions and technical performance of machine tool with this
CNC system are determined by machine builder’s design, so refer to its user
manual.
� The system is employed with integrated machine control panel and the keys
on machine control panel are defined by PLC program. Functions of keys in
this user manual are for standard PLC program. Please notice it!
� Refer to user manual from machine manufacturer about functions and
meanings of keys on machine control panel.
Announcement！
� This manual describes various items as much as possible. However,
operations allowable or unallowable can not be explained one by one due to
so many possibilities that may involve with, so the contents that are not
specially stated in this manual shall be considered to be unavailable.
Summary
To Next Page
Loading...
Need help?
General