TOMATECH AUTOMATION
Note: The axis names of Y, the 4th, the 5th axis is defined by No.225.
2） MACRO interface
There are 25 pages in this interface, which can be shown by pressing or key. In
Macro window there are 600 (No.100～No.199 and No.500～No.999) macro variables
which can be specified by macro command or set directly by keypad. The public variable
page is shown below:eration
The local variable page is shown below:
The system variable page is shown below:
Ⅱ Operation
Note: The local variable and the system local are specified by macro codes instead of directly set
by the
keyboard in the page.
3） Workpiec coordinate system setting
4） Tool life management
Chapter 1 Operation Mode and Display Interface
193
Ⅱ Operation
1.3.4 ALARM interface
1) Alarm:
Press key to enter alarm interface including , which can be
switched by pressing repetitively , or the corresponding soft function. The alarm interface
is
shown below:
1） Alarm information page
Note: Alarm clearing: It can clear alarms by pressing .
194
Ⅱ Operation
2） Alarm log page
1.3.5 Setting interface
Press to enter the SETTING interface including
which can be switched by pressing repetitively or corresponding soft keys. The interface is
shown below:
Note 1: *1, *2 soft function menus are displayed but *3 is not done when the cursor is in the
switch setting
column in page; *1, *2 soft function menus are not displayed but *3 is done when the cursor
is in the privilege setting or parameter setting column;
Note 2: *4 soft function menu is displayed to (Copy to U disk) when the cursor is in CNC directory
in
page; it is displayed to (Copy to CNC) when the cursor is in U disk directory;
Note 3: *5 soft function menu is displayed to (Select) when the system enters into page and the
item where the cursor is has not selected; it is displayed when the item has selected.
To Next Page
Loading...
Need help?
General