TOMATECH TAC-100XT - Y Address (Plc→Machine, Defined by Standard PLC Ladders)

TOMATECH AUTOMATION
LMIY: Y overtravel input
LMIX: X overtravel input
X0005 *** *** *** *** SALM COIN SAR VPO
SALM: spindle abnormality alarm input
COIN: spindle orientation completion signal
SAR: spindle speed arrival
VPO: spindle position/speed control state
X0006 *** *** ×100 ×10 ×1 ZHAN YHAN XHAN
×100: increment ×100（external）
×10: increment×10（external）
×1: increment×1（external）
ZHAN: Z selection（external）
YHAN: Y selection（external）
Chapter 5 Diagnosis Message
427
Ⅲ Connection
XHAN: X selection（external）
5.2.2 Y address (PLC→machine, defined by standard PLC ladders)
Y0000 SPZD SCLP M05 M04 M03 *** M32 COOL
SPZD: spindle brake
SCLP: spindle clamped
M05: spindle stop
M04: spindle rotation CCW
M03: spindle rotation CW
M32: lubricating output
COOL: cooling output
Y0001 TL- TL+ DOQPS DOQPJ S4/M44 S3/M43 S42/M42 S41/M41
TL-: TL-tool post rotation (CW)
TL+: TL+tool post rotation(CCW)
DOQPS: chuck release
DOQPJ: chuck clamp
S4/M44: spindle mechanical 4-gear
S3/M43: spindle mechanical 3-gear
S2/M42: spindle mechanical 2-gear
S1/M41: spindle mechanical 1-gear
Y0002 VP2 DOTWS DOTWJ CLPR CLPG CLPY INDXS TZD
VP2: the 2nd spindle speed/position switch output
DOTWS: tailstock going backward
DOTWJ: tailstock going forward
CLPR: three-color lamp-red
CLPG: three-color lamp-green
CLPY: three-color lamp-yellow
INDXS: tool post worktable pregraduation coil
TZD: tool post worktable brake