TOMATECH AUTOMATION
Y0003
UO5/SP
2
UO4/SP
1
UO3/SP
0
U2/M64/STA
O
U1/M6
3
U0/TAP
2
HPS
T
SVF
UO5/SP2: user macro output 5／orientation position 2
UO4/SP1: user macro output 4／orientation position 1
UO3/SP0: user macro output 3／orientation position 0
U2/M64/STAO: user macro output 2/the 2nd spindle CCW/orientation start signal
U1/M63: user macro output 1/the 2nd spindle CW
U0/TAP2: user macro output 0/the 2nd gain selection signal of the 2nd spindle speed
loop(rigid
tapping)
HPST: hydraulic control output
SVF: spindle servo OFF (reduce the spindle servo excitation)
Y0005 *** *** *** *** SRV SFR TAP VP
SRV: spindle rotation(CW)
428
Ⅲ Connection
SFR: spindle rotation(CCW)
TAP: the 2nd gain selection signal of the spindle speed loop
VP: spindle position／speed control switch output
Chapter 5 Diagnosis Message
429
Ⅲ Connection
5.2.3 Machine panel
X20.0
Y21.7
X19.4
Y19.7
X19.5
Y19.6
To Next Page
Loading...
Need help?
General