TOMATECH AUTOMATION
1 PAO-
17 PBO+
2 PBO-
18 PZO+
3 PZOCN21
8 PAS
7 *PAS
6 PBS
5 *PBS
4 PZS
3 *PZS
19 EN5
21 TAP 41 TAP
6 SAR 5 SAR
3/9
23/35
37/38
� Wiring diagram betweenTAC-1002T and GS3000Y-N spindle servo unit (the 5th
axis is
Cs axis in the following example)
TAC-100XT signal interface GS3000Y-N signal interface
TAC-100XT signal interface DAP03 signal interface
350
Ⅲ Connection
Note 1: CN15 signal interface onTAC-1002T side adopts DB25 2-stripe male plug, CN21 adopts
DB15
2-stripe female plug.
Note 2: GS3000 Series signal interface CN1 adopts DB44 3-stripe male plug.
2.8.9 Multiple spindle function
When the multiple spindle function is valid, related signals, parameters and commands
are
consistent with related explanations of the spindle control, the 1st, the 2nd spindle
explanations are
shown below.
� Related signals（defined by PLC program）
Type Sign Interface Address Function Remark
VPO2 CN61.40 X3.3
The 2nd spindle speed/position control
Input state
signal
SALM2 CN61.41 X3.4 The 2nd spindle abnormality alarm signal
Multiplex with
the chuck
To Next Page
Loading...
Need help?
General