TOMATECH AUTOMATION
e.g. To input character “［”, it may press key repeatedly.
Note: The system cannot execute the program search and the scan in macro program edit state.
6.1.12 Creating and modifying a program annotation
TAC-100XT can add annotation to each line, and its steps are shown below:
1) Select Edit mode, press to enter program interface, press to enter the
program content page;
2) Press and the CNC automatically insert “( )” into the end of line where the cursor
is, and the display page is shown below:
Chapter 6 Program Edit and Management
235
Ⅱ Operation
3) Input annotation character into “( ). For example, input “KUAI” character string, and the
display page is shown below:
4) The modification of annotation is the same that of program content.
Note : The annotation added to the CNC could only be character. Actually, the CNC takes all
content in “()”
as annotation, so, adding other annotation can be executed by using PC editing, and then be
transmitted to the CNC.
6.2 Deleting Programs
6.2.1 Deleting a program
Steps:
1) Select Edit mode, press to enter program interface, press to enter
program content page;
236
Ⅱ Operation
2) Press address key , number key , , , by sequence (taking
example of O0001);
3) Press key, pop-up the dialog box as follows:
4) Press and O0001 program is deleted; press and the deletion is cancelled.
Method 2:
1) Select Edit mode, press to enter program interface, press to enter the local program
page;
2) Press or to select the required deleted program. For example, select O0001
program and the display is shown below:
Chapter 6 Program Edit and Management
237
Ⅱ Operation
3) Press key, pop-up the dialog box as follows:
4) Press and O0001 program is deleted; press and the deletion is cancelled.
To Next Page
Loading...
Need help?
General