TOMATECH TAC-100XT User Manual

TOMATECH AUTOMATION
Ⅱ Operation
1) Press in Edit mode to enter program interface, and press to enter program
content page.
2) Move the cursor to the head of the block to be deleted, then press key.
6.1.8 Copying and pasting a block
Steps:
1) Select Edit mode, and the program content page is displayed;
2) Move the cursor to the required copy block, press , and the current block is
copied;
3) Move the cursor to the required paste position, press , and the copied block is
pasted.
6.1.9 Canceling and recovering a program
Steps:
1) Select Edit mode, the program content page is shown below:
Chapter 6 Program Edit and Management
233
Ⅱ Operation
2) Press to enter the next menu, which is shown below:
3) When the current content is changed(after modification, copy or deletion), is
pressed to recover the previous content before the copy;
4) Recover and cancel are matched. Press ， to cancel the previous
operation.
6.1.10 Program save
In Edit mode, after the program is edited or modified, although the system automatically
save
programs at regular time, the operator can select the operation to save the current
program, which
method is shown below:
Method 1：
In the program content page, press to enter the next menu, press to save
the program into the CNC.
Method 2:
Switch the current display page and the CNC will automatically save the current program.
234
Ⅱ Operation
Note: “*” in the title bar is displayed when the program is not saved.
6.1.11 Macro program edit
Press key repeatedly, it enters MACRO state, as the following window shows:
Then it may input some special characters (［, ］, ＝, ＞, ＜, ＋, ＊).

TOMATECH TAC-100XT Specifications

General

Brand	TOMATECH
Model	TAC-100XT
Category	Control Systems
Language	English