TOMATECH AUTOMATION
2) Press to input a new program name;
3) Press .
Chapter 6 Program Edit and Management
243
Ⅱ Operation
Method 2:
1) Select Edit mode, press to enter the program interface, and in necessity press
to enter the local directory page:
2) Press again to enter the subordinate menu, and press to open it:
3) Move the cursor to the program which is to be modified, press and input a new
program name in the pop-up diaglog box, and at last press .
Note: the method 1 is only used to the current program, and the method 2 is used to any
programs.
244
Ⅱ Operation
6.7 Program Management
6.7.1 Program list
Press ,and then press to enter the local program display page. In the page, it
lists the program names saved in CNC system, and it can display up to 18 names in a
page. When
the saved exceed 18 programs, it may press or to display the next page.
Explanations:
1) The area 1 is used to display the saved programs, the total memory capacity, the used
capacity and the left;
2) The area is used to display the current program list;
3) The area 3 is used to preview the content of program where the current cursor is in the
area
2;
4) The area 4 belongs to the soft function menu position. Pressing ,
can display in order programs located at the area 2.
6.8 Other Operations Available in Edit Mode
The operations by thisTAC-1002T machine panel allowed in Edit mode are defined by
ladders,
please refer to the materials by the machine builder.
Please note that the following functions are described based on the 980TDc standard PLC
programs!
1) Spindle override can be adjusted by pressing , ;
2) Feedrate override can be adjusted by pressing , ;
3) CNC can be reset by pressing key;
Area 1
To Next Page
Loading...
Need help?
General