TOMATECH TAC-100XT - PARAMETER Interfaces; Diagnosis Interface; Graph Interface

TOMATECH AUTOMATION
Chapter 1 Operation Mode and Display Interface
195
Ⅱ Operation
1) CNC setting page
2) System clock page
3) Document management page
196
Ⅱ Operation
1.3.6 PARAMETER Interfaces
Press to enters PARAMETER interface including pages , ,
, which can be switched by pressing repetitively or the corresponding
soft keys. The interface is shown below:
1) Bit parameter page
Chapter 1 Operation Mode and Display Interface
197
Ⅱ Operation
2) Data parameter page
3) Common used parameter page
198
Ⅱ Operation
4) Pitch compensation parameter page
1.3.7 Diagnosis Interface
Press to enter diagnosis interface including pages which can be
switched by pressing repetitively or the corresponding soft keys. The interface is shown
below:
：
1) System diagnosis page
Chapter 1 Operation Mode and Display Interface
199
Ⅱ Operation
The page is used to detect CNC interface signal and its inner run state. Please refer to
INSTALLATION, Section 5.1.
2) System information page
1.3.8 Graph Interface
Press to enter GRAPH interface. The interface is shown below:
200
Ⅱ Operation
Graph page is shown below: