TOMATECH AUTOMATION
［Data unit］
Set unit IS-B IS-C
Metric machine 0.001 mm 0.0001 mm
Inch machine 0.0001 inch 0.00001 inch
Data range 2000 20000
［Data range］ 0～2000
Note: X is diameter value.
0 9 6 PECMINn
［Data type］ Word axis
［Data meaning］ Minimum pitch error compensation number
［Data range］ 0～1023
0 9 7 PECMAXn
［Data type］ Word axis
［Data meaning］ Maximum pitch error compensation number
［Data range］ 0～1023
0 9 8 PECORGn
［Data type］ Word axis
［Data meaning］ Pitch error compensation number corresponding to machine zero
［Data range］ 0～1023
0 9 9 PECINTn
［Data type］ Word axis
［Data meaning］ Pitch error compensation intervals
［Data unit］
Setting unit IS-B IS-C
Metric machine 0.001 mm 0.0001 mm
402
Volume Ⅲ Connection
Inch machine 0.0001 inch 0.00001 inch
［Data range］
IS-B IS-C
Metric machine 1000～999999 10000～9999999
Inch machine 400～999999 4000～9999999
3.2.4 Machine protection
1 7 2 *** MST MSP MOT ESP *** LZR ***
Bit6 1: External cycle start signal (ST) inactive, it is not the cycle start switch and can be
defined by
macro code (#1014)；
0: External cycle start signal (ST) active.
Bit5 1: External SP signal inactive, and it is not the dwell switch and can be defined by
macro code.
( #1015)；
0: External SP signal active with external dwell switch connected, otherwise CNC shows
“stop”.mailto:M@SP=1
To Next Page