TOMATECH AUTOMATION
� Max. speed 60m/min（up to 24m/min in 0.1μm）
� Adapting to the servo spindle to realize the spindle continuously positioning, rigid
tapping, and the rigid thread machining
� Built-in multi PLC programs, and the PLC program currently running can be selected
� G71 supporting flute contour cycle cutting
� Statement macro command programming, macro program call with parameter
� Metric/inch programming, automatic toolsetting, automatic chamfer, tool life
management function
� Chinese, English, Spanish, Russian display can be selected by parameters.
� USB interface, U disc file operation, system configuration and softwareⅠ
� 2-channel 0V～10V analog voltage output, two-spindle control
� 1-channel MPG input, MPG function
� 41 input signals and 36 output signals
� Appearance installation dimension and command system are compatible with those of
TOMATECH
1.1.2 Technical specification
� Controllable axes
� Controllable axes: 5（X, Z, Y , 4th,5th）
� Link axes：3
� PLC controllable axes：3（X, Z, Y, 4th,5th）
� Feed axis function
� Least input increment: 0.001mm（0.0001inch）and 0.0001mm（0.00001inch）
� Least command increment：0.001mm（0.0001inch）and 0.0001mm（0.00001inch）
� Position command range: ±99999999× least command unit
� Rapid traverse speed：max. speed 60m/min in 0.001mm command unit, max. speed
24m/min in 0.0001mm command unit
� Rapid override: F0, 25%, 50%, 100%
� Feedrate override: 0～150% 16 grades to tune
� Interpolation mode: linear interpolation, arc interpolation(three-point arc interpolation),
thread interpolation, ellipse interpolation, parabola interpolation and rigid tapping
� Automatic chamfer function
� Thread function
� General thread(following spindle)/rigid thread
� Single/multi metric, inch straight thread, taper thread, end face thread, constant pitch
thread and variable pitch thread
� Thread run-out length, angle, speed characteristics can be set
� Thread pitch: 0.01mm～500mm or 0.06 tooth/inch～2540 tooth/inch
� Acceleration/deceleration function
� Cutting feed: linear
� Rapid traverse: linear, S
� Thread cutting: linear, exponential
� Initial speed, termination speed, time of acceleration/deceleration can be set by
parameters
� Spindle function
To Next Page