TOMATECH TAC-100XT - Environment and Conditions; Power Supply; Guard

TOMATECH AUTOMATION
� G command table
code
Function
code
function
G00
Rapid traverse(positioning)
G50
Float coordinate setting
G01
Linear Interpolation
G54-
G59
Set workpiece coordinate
G02
Clockwise circular interpolation
G65
Macro calling(no modal)
G03
Anti-clockwise circular interpolation
G71
Axial roughing cycle
G04
Pause/ Orientation
G72
Radial roughing cycle
G17
Plane selection
G73
Closed cutting cycle
G18
Plane selection
G70
Finishing cutting cycle
G19
Plane selection
G74
Axial grooving cycle
G10
Data input available
G75
Radial roughing cycle
G11
Data input cacel
G76
Multiple threading cutting
G20
Inch unit
G80
Rigid tapping status cancel
G21
Metric input
G84
Axial rigid tapping
G28
Return to home position
G88
Radial rigid tapping
G30
Return to machine 2,3,4 ref.point
G90
Axial cutting cycle
G31
Skip function
G92
Threading cycle
G32
Constant pitch threading
G94
Radial cutting cycle
G33
Z axes tapping cycle
G96
Constant speed cutting
G34
Variable pitch threading
G97
Constant speed cutting cancel
G40
Cancel tool nose radius
compensation
G98
Feed per minute
G41
Left tool nose radius compensation
G99
Feed per revolution
G42
Right tool nose radius compensation
1.1.3 Environment and conditions
TAC-100XT storage delivery, working environment as follows:
Item Working conditions Storage delivery conditions
Ambient temperature 0℃～45℃ -40℃～+70℃
Ambient humidity ≤90%(no freezing) ≤95%(40℃)
Atmosphere pressure 86 kPa～106 kPa 86 kPa～106 kPa
Altitude ≤1000m ≤1000m
Chapter 1 Programming
Ⅰ Programming
1.1.4 Power supply
TAC-100XT can normally run in the following AC input power supply.
Voltage: within(0.85～1.1)×200V (rated AC input voltage);
Frequency: 49Hz～51Hz continuously changing
1.1.5 Guard
TAC-100XT guard level is not less than IP20.