TOMATECH TAC-100XT - PLC Axis Control Function; Skip Function; Automatic Tool Setting Function

TOMATECH AUTOMATION
0: In STEP(MPG) mode and when the system increment is 1u, ×1000 gear is valid，
Note: to avoid the step-out, the parameter should be set to 1 when the system is matched with the
stepper
drive unit.
3.2.14 PLC axis control function
1 8 5 *** *** *** PRPD PLA
PRPD 1: Rapid traverse rate of PLC axis by input value
0: Rapid traverse rate of PLC axis by parameter value (X axis: No.022； Z axis:No.023；
Y
axis:No.155;)
PLA 1: PLC axis control active, and active after repowering
0: PLC axis control inactive, and active after repowering
Note: The PLC axis control function is only provided by machine builder.
2 1 9 PLCDIDOn
［Data type］ Word axis
［Data meaning］ Select DI/DO in PLC axis control PLC
［Data unit］
［Data range］ 0～4
3.2.15 Skip function
1 8 5 SK0 SKF *** *** ***
SK0 1: Skip input active as G31 signal is 0
0: Skip input active as G31 signal is 1
SKF 1: Feedrate override per minute or dry run active for G31
0: Feedrate override per minute or dry run inactive for G31
Note: The skip function is only provided by machine builder.
3.2.16 Automatic tool setting function
1 8 5 AEO *** *** ***
AWO 1: when G36, G37 signal（XAE，ZAE）is 0, the input is valid;
0: G36, G37 signal（XAE，ZAE）is 1, the input is valid.
1 4 1 AUTO_OFFSET_FEED
［Data meaning］ feedrate in automatic tool compensation measure.
412
Volume Ⅲ Connection
［Data unit］
Set unit Data unit
Metric machine mm/min
Inch machine 0.1inch/min
［Data range］
IS-B IS-C
Metric machine 15～1000 15～1000
Inch machine 7～375 7～375
1 4 2 AUTO_OFFSET_Y_X
1 4 3 AUTO_OFFSET_Y_Z