TOMATECH AUTOMATION
0 7 2 The pulse number from the time that 4th axis starts detecting PC signal
to PC signal is detected
0 7 3 The pulse number from the time that 5th axis starts detecting PC signal
to PC signal is detected
0 7 4 The times of system powering off
0 7 5 The times of system undervoltage (when the power is not off)
0 7 6 The times of insufficient time for data saving when the system is
undervoltage
5.1.3 Diagnosis keys
DGN.016～DGN.022 are the diagnosis messages of edit keypad keys; DGN.024～
DGN.029 are
the diagnosis messages of machine operation panel keys. When pressing a key in the
operation
panel, the corresponding bit displays “1”, and “0” after releasing this key. If it displays
reversely, it
means there is a fault in the keypad circuit.
0 1 6 RST O N G P/Q 7 8 9
Key
0 1 7 PGU X Z U W 4 5 6
Key
0 1 8 PGD H/Y F/E R/V D/L 1 2 3
Key
0 1 9 CRU RIGHT I/A J/B K/C - 0 .
Chapter 5 Diagnosis Message
425
Ⅲ Connection
Key
0 2 0 CRD LEFT M S T EOB INS/ALT DEL
Key
0 2 1 IN OUT CHG /,# CAN
Key
0 2 2 POS RPG OFT ALM SET PAR DGN GRA
Key
0 2 3 FLEFT F1 F2 F3 F4 F5 FRIGHT PLC
Key
5.1.4 Others
0 7 1 BOOT version No.
1 1 8 PLC execution time(ms)
1 1 9 Execution all time (h)
0 2 1 IN OUT CHG /,# CAN
Key
0 2 2 POS RPG OFT ALM SET PAR DGN GRA
Key
0 2 3 FLEFT F1 F2 F3 F4 F5 FRIGHT PLC
To Next Page
Loading...