TOMATECH TAC-100XT - Communication Setting

TOMATECH AUTOMATION
0: Cursor to beginning by pressing CYCLE START key after M30
0 1 2 ALM&
PRG
Bit3 1: Program editing allowed during CNC alarming
0: Program editing unallowed during CNC alarming
1 8 0 SPOS
Bit0 =1: DIS TO GO displayed in POS&PRG page
=0: RELATIVE POS displayed in POS&PRG page
1 8 4 *** PTEST *** *** *** L2 L1 L0
Bit0, Bit1, Bit2: Interface language selection
Language Bit2 Bit1 Bit0
Chinese 0 0 0
English 0 0 1
Portugal 0 1 0
Spanish 0 1 1
Russian 1 1 0
3.2.12 Communication setting
0 4 4 BRATE0
［Data meaning］ baud rate of serial communication.
［Data unit］ bit/s
［Data range］ 1200,2400,4800,9600,19200,38400,57600 ,115200
3.2.13 MPG Parameters
0 0 1 *** *** MPG
Bit3 1: MPG mode
0: Step mode
0 1 3 *** *** *** HW5 HW4 HWY HWZ HWX
Bit4 1: coordinates increase when 5th MPG rotates CCW;
0: coordinates increase when 5th MPG rotates CW.
Bit3 1: coordinates increase when 4th MPG rotates CCW；
0: coordinates increase when 4th MPG rotates CW.
Bit2 1: coordinates increase when Y MPG rotates CCW；
0: coordinates increase when Y MPG rotates CW.
Chapter 3 Parameters
411
Volume Ⅲ Connection
Bit1 1: coordinates increase when Z MPG rotates CCW；
0: coordinates increase when Z MPG rotates CW.
Bit0 1: coordinates increase when X MPG rotates CCW；
0: coordinates increase when X MPG rotates CW.
K 1 6 SINC SINC2 *** *** *** *** *** ***
Bit7 1: In STEP(MPG) mode and when the system increment is 0.1u, ×1000 gear is
invalid，
0: In STEP(MPG) mode and when the system increment is 0.1u, ×1000 gear is valid，
Bit6 1: In STEP(MPG) mode and when the system increment is 1u, ×1000 gear is invalid，