TOMATECH AUTOMATION
1 8 7 IS1 IS0
[Data type]: Bit axis
BIT7, BIT6：set increment system of each axis. 00：accordance with increment system of
the
system; 01：IS-A，10：IS-B；11：IS-C.
2 0 3 *** *** *** ABP5 ABP4 ABPY ABPZ ABPX
Bit4 1: 5th pulse outputs according to the two-phase quadradure (need to power-on again);
0: 5th pulse outputs according to (pulse + direction) (need to power-on again).
Bit3 1: 4th pulse outputs according to the two-phase quadradure (need to power-on again);
0: 4th pulse outputs according to (pulse + direction) (need to power-on again).
Bit2 1: Y pulse outputs according to the two-phase quadradure (need to power-on again);
0: Y pulse outputs according to (pulse + direction) (need to power-on again).
Bit1 1: Z pulse outputs according to the two-phase quadradure (need to power-on again);
0: Z pulse outputs according to (pulse + direction) (need to power-on again).
Bit0 1: X pulse outputs according to the two-phase quadradure (need to power-on again);
0: X pulse outputs according to (pulse + direction) (need to power-on again).
3.2.2 Acceleration & deceleration control
0 2 2 RPDFn
［Data type］ Word axis
［Data meaning］ max. speed of X rapid traverse (radius value)
［Data unit］
Setting unit Data unit
Metric machine mm/min
Inch machine 0.1inch/min
［Data range］ 10～99999999
0 2 3 LINTn
［Data type］ Word axis
［Data meaning］Acceleration/deceleration time constant value
［Data unit］ ms
［Data range］ 10～4000
0 2 7 FEDM
［Data meaning］ Upper limit of cutting feedrate
［Data unit］
Setting unit Data unit
Chapter 3 Parameters
399
Volume Ⅲ Connection
Metric machine mm/min
Inch machine 0.1inch/min
［Data range］
IS-B IS-C
Metric machine 10～15000 10～15000
Inch machine 5～5800 10～5800
0 2 9 FEEDT
To Next Page