TOMATECH AUTOMATION
TOMATECHComm software takes an administrator as a unit to complete management.
When it run
firstly, it does not upload project files, at the moment, the user should create an project
program or
upload project to execute the communication operation. The display is shown below after
the an
project is created:
Chapter 13 Communication
291
Ⅱ Operation
At the mode, the user can receive the files from the CNC to the current project or send
files in the
current project to the CNC.
12.1.3 Receiving files (CNC→PC)
Click the option [Receive files from CNC] in [Communication] and TOMATECHComm can
receive files
from the CNC after the current project is selected as follows:
After [Receive Files ] is clicked, a dialog box about receiving files from the CNC, the
required files
from the CNC including part programs, tool compensation (TOFF. CMP), pitch
compensation
(WOFF.WMP), parameters (PARAM.PAR).
292
Ⅱ Operation
After the user selects the required file, [ Start Receiving ] is pressed and the system pops
up a
path selection dialog box to save the received files as follows:
Select the save path, start to receive the file from CNC to PC by pressing [确定, i.e.
Confirm] as
follows:
Chapter 13 Communication
293
Ⅱ Operation
After the receiving is done, the system displays below:
12.1.4 Sending files (CNC→PC)
After the current project file is selected, the user clicks [Send projects to CNC] in the menu
[Communication], and so the receiving file from CNC is done. A dialog box to send files to
CNC is
popped up as follows:
294
To Next Page
Loading...
Need help?
General