TOMATECH TAC-100XT User Manual

TOMATECH AUTOMATION
Example 1:
O0001;
G0 X100 Z100; (rapid traverse to X100 Z100; the modal G0 is valid)
X20 Z30; (rapid traverse to X20 Z30; the modal G0 is not input)
G1 X50 Z50 F300; (linear interpolation to X50 Z50, feedrate 300mm/min; the modal G1 is
valid)
X100; (linear interpolation to X100 Z50, feedrate 300mm/min; Z coordinate is
not input and is the current coordinates Z50; F300 is kept, G1 is modal
and is not input)
G0 X0 Z0; (rapid traverse to X0 Z0 and the modal G0 is valid)
M30;
Example 2:
O0002;
G0 X50 Z5; (rapid traverse to X50 Z5)
G04 X4; (dwell 4 seconds)
G04 X5; (dwell 5 seconds again, G04 is non-modal and is needed to input again)
M30;
Example 3 (the first run after power-on) :
O0003;
G98 F500 G01 X100 Z100; (Feedrate per minute 500mm/min in G98)
G92 X50 W-20 F2 ; (F value is a pitch and must be input in thread cutting)
G99 G01 U10 F0.01 (Feedrate per revolution in G99 must be input again)
G00 X80 Z50
M30;
3.1.3 Related definitions
In the user manual, the definitions of Word are as follows except for the especial
explanations:
Starting point: position before the current block runs;
End point: position after the current block ends;
X: X absolute coordinates of end point;
U: different value of absolute coordinates between starting point and end point;
Z: Z absolute coordinates of end point;
W: different value of absolute coordinates between starting point and end point;
F: cutting feedrate.
3.2 Rapid Traverse Movement G00
Command format: G00 X(U) Z(W) ;
Command function: X, Z rapidly traverses at the respective traverse speed to the end
points from their starting point. G00 is initial command as Fig.3-1.
X, Z traverses at the respective traverse speed, the short axis arrives the
end point and the length axis continuously moves to the end point and the
compound path may be not linear.
Command specification: G00 is initial mode;

TOMATECH TAC-100XT Specifications

General

Brand	TOMATECH
Model	TAC-100XT
Category	Control Systems
Language	English