TOMATECH TAC-100XT - G Address (PLC→CNC)

TOMATECH AUTOMATION
CINP: G04 code being executed
CDWL: RS232 interface being receiving
F0213 *** *** *** *** *** *** CTRD CTPU
CTRD: RS232 interface being transmitting
CTPU: Spindle jog/lubricating selection
F0214 *** *** *** VAL5 VAL4 VALY ZVAL XVAL
VAL5: 5th axis direction selection
VAL4: 4th axis direction selection
VALY: Y direction selection
VALZ: Z direction selection
VALX: X direction selection
5.2.5 G address (PLC→CNC)
G0004 *** *** *** *** FIN *** *** ***
FIN: MST function end signal
G0005 *** AFL *** *** *** *** *** ***
AFL: MST lock signal
SFIN: Spindle S function end signal
G0006 *** SKIPP *** OVC *** ABSM *** SRN
OVC: Feedrate override cancel signal
SRN: Program restart signal
G0007 RLSOT EXLM *** *** *** ST STLK ***
ST: Cycle start signal
436
Ⅲ Connection
G0008 ERS RRW SP ESP *** *** *** IT
ERS: External reset signal
RRW: Reset and cursor return signal
SP: Feed hold signal
ESP: Emergency stop signal
G0010 JV07 JV06 JV05 JV04 JV03 JV02 JV01 JV00
G0011 JV15 JV14 JV13 JV12 JV11 JV10 JV09 JV08
JOG override signal JV00~JV15
G0012 FV07 FV06 FV05 FV04 FV03 FV02 FV01 FV00
Feedrate override signal FV00~FV07
G0014 *** *** *** *** *** *** RV2 RV1
RV2: Rapid feedrate override signal RV2
RV1: Rapid feedrate override signal RV1
G0018 *** *** *** *** HD HC HB HA
HD: MPG feed selection signal (01004th)
HC MPG feed selection signal (01015th)
HB: MPG feed selection signal (0011Y)
HA: MPG feed selection signal (0001X. 0010Z)
G0019 RT *** MP2 MP1 *** *** *** ***