TOMATECH AUTOMATION
Area 4
Area 2 Area 3
Chapter 6 Program Edit and Management
245
Ⅱ Operation
4) The operation mode is switched by pressing any of the keys among , , ,
, or ;
5) The data transmission
6) Refer to II OPERATION, Chapter 12
7) Cooling control
Refer to II Operation, Section 3.2.3
8) Lubricating control
Refer to II Operation, Section 3.2.4
9) Chuck control
Refer to II Operation, Section 3.2.5
10) Tailstock control
11) Refer to II Operation, Section 3.2.6
12) Hydraulic control
Refer to II Operation, Section 3.2.7
246
Ⅱ Operation
CHAPTER 7 TOOL OFFSET AND SETTING
The actual location of tool can be overlooked in programming for simplifying programming.
Three
methods including positioning toolsetting, trial toolsetting and machine zero toolsetting are
available
in thisTAC-1002T system. The tool offset data are obtained from this toolsetting operation.
7.1 Tool Positioning Setting
Steps:
x
Z
X
Z
Fig. A Fig. B
1. Firstly determine if the offset values are zero in X, Z, if not, clear all the tool number
offset
values;
2. Set the offset No. for 00 (i.e. T0100,T0300), as for the offset value: (method: execute a
move
code or perform the machine zero return in T0100 state, then clear the offset value
automatically as returning to the machine zero);
To Next Page
Loading...
Need help?
General