TOMATECH AUTOMATION
window, is pressed and the file in the CNC is copied to the U disk.
11.3 Data Copy and Resume
In the file managemetn page, backup, resume the CNC data (including the system
parameters,
part parameter, tool compensation, pitch compensation, ladder parameters, ladder, alarm
log and so
on) via the U disk.
11.3.1 Entering backup/resume page
After the system identifies the U disk, it enters the file management page. Press to
enter the backup/resume page as follows:
Chapter 13 Communication
287
Ⅱ Operation
11.3.2 Backup/resume operation
1) Press , , , to move the cursor to the required option;
2) Press （or ）to select the required option to be backup/resumed;
3) Press (or ) to cancel the selection when the cursor has been in the
selected option;
4) Press or to select or cancel all selection;
5) Press （or ）to execute the current selected.
Note 1: Data which has been backup or has been done to store in the U disk can be resumed.
Note 2: When the cursor is in the “BACKUP OPTION” column, all options in the the “RESUME
OPTION”
column cannot be selected; when the cursor is in the “RESUME OPTOIN”, all options in the
“BACKUP
OPTION” column cannot be selected;
Note 3: Pressing executes operations only in the column where the cursor is. When the cursor
is in “BACKUP OPTION” column, the resume operation is executed. The backup, resume cannot
be executed
simultaneously.
11.3.3 Operation path selection
When the user uses the U disk to execute the CNC data backup, the CNC creates a
backup file
“TAC-100XT_backup” in the root catalog of the U disk. The backup file includes two
backup data “U:\
TAC-100XT_backup\user” and “U:\TAC-1002T_backup\serial number” (it is created by
the system’s
serial number). When the user uses one U disk to execute data backup of many CNC
systems, the
data in “U:\TAC-1002T_backup\user” is replaced by the new but data in
To Next Page
Loading...
Need help?
General