TOMATECH TAC-100XT User Manual

TOMATECH AUTOMATION
3) Pressing can enter the subordinate menu, which can be omitted. The display is
shown below:
4) Press ， to move the cursor to the program name which is to be selected.
5) Refer to the above Step 3) to enter the subordinate menu, at the moment, press directly
to open it. The step can be omitted to execute the Step 6).
6) Press or , and the selected program is opened and the CNC skips to “PRG.
CONTENT” page.
Note: when the CNC is connected with the U disk, the above similar method is referred to open
the program in
the U disk.
6.4 Executing a Program
After the program to be executed is selected by the method in OPERATION, Section 6.3,
select the
Auto mode, then press key (or external cycle start key), the program will be executed
Chapter 6 Program Edit and Management
241
Ⅱ Operation
automatically.
6.5 Renaming a Program
Methods of renaming a program is divided into two:
Method 1:
1) Select Edit mode, press to enter the program interface, and in necessity press
to enter PRG CONTENT page (must be in Insert, Alter state):
2) Press to input a new program name;
3) Press .
Method 2:
1) Select Edit mode, press to enter the program interface, and in necessity press
to enter the local directory page:
242
Ⅱ Operation
2) Press again to enter the subordinate menu, and press to open it:
3) Move the cursor to the program which is to be modified, press and input a new
program name in the pop-up diaglog box, and at last press .
Note: the method 1 is only used to the current program, and the method 2 is used to any
programs.
6.6 Copying a Program
Methods of copying a program is divided into two:
Method 1:
1) Select Edit mode, press to enter the program interface, and in necessity press
to enter PRG CONTENT page (must be in Insert, Alter state):

TOMATECH TAC-100XT Specifications

General

Brand	TOMATECH
Model	TAC-100XT
Category	Control Systems
Language	English