TOMATECH TAC-100XT - Parameter Description (by Sequence); Bit Parameter

TOMATECH AUTOMATION
369
Volume Ⅲ Connection
CHAPTER 3 PARAMETERS
The CNC bit and data parameters are described in this chapter, various functions can be
set by
these parameters. The major parameter data type are listed as follows:
Data type Range
(1) Bit
(2) Bit axis
(3) Bit spindle
8 bit, 0 or 1
(4) Word
(5) Word axis
(6) Word spindle
See relevant
parameters for
details
Note: if the data type is not specified, the type is bit or word.
3.1 Parameter Description (by sequence)
3.1.1 Bit parameter
The state parameter is expressed as follows:
Parameter No. BIT7 BIT6 BIT5 BIT4 BIT3 BIT2 BIT1 BIT0
0 0 1 *** *** *** ACS MPG PROG ISC INI
Bit4 1: Spindle analog voltage control
0: Spindle switching volume control
Bit3 1: MPG mode
0: Step mode
Bit2 1: Programming by radius
0: Programming by diameter
Bit1 1: IS-C incremental system
0: IS-B incremental system
Increment system Least input increment,
least command increment
Abbreviation
0 0.001mm,0.0001inch IS-B
1 0.0001mm, 0.00001inch IS-C
Bit0 1: Inch input
0: Metric input
0 0 2 CLK *** *** LIFJ MDITL LIFC TNRC TLIF
Bit7 1: Show clock
370