TOMATECH AUTOMATION
1.3.9 Ladder Interface
Press to enter LADDER interface including pages , , ,
which can be switched by pressing repetitively or corresponding soft keys. The
interface is shown below:
Chapter 1 Operation Mode and Display Interface
201
Ⅱ Operation
1) PLC I/O state page
The page can display PLC I/o state information.
2) Ladder monitor page
202
Ⅱ Operation
The monitor page can view states of current contact, coil ON/OFF state, values of timer
and
counter. They are displayed with a green background when they are ON, otherwise, they
are the
same those of the page background. means the contact X0.5 is ON, means Y25.2 is
OFF.
1. page program view
In MONITOR page, the system can monitor simultaneously three windows, the ladder
blocks
corresponded to each window can be viewed by separately pressing , ,
, at the moment, the ladder corresponded to the selected block is displayed on the
screen.
2. Window block selection
（1）Select the window which needs to select blocks, press respectively , ,
to select the windows.
（2）Press to select the window program. At the moment, the display page is shown
below:
Chapter 1 Operation Mode and Display Interface
203
Ⅱ Operation
（3）Move the cursor to select the ladder block for display.
（4）Press , and then return the previous menu, press to cancel the
selection operation to return to the previous menu.
3. Find parameters, commands and network
（1）Select the required block window for finding commands, parameters and network,
make the
corresponding block display in the window, and find the command, parameters and
network
in the window.
（ 2 ） Respectively press to find the corresponding
To Next Page
Loading...
Need help?
General