TOMATECH AUTOMATION
T0011 Spindle brake output timing
T0012 Spindle jog timing
T0013 timing the lubricating jog output time
T0018 Chuck pulse output timing
T0021 Spindle stop, check operation enabling delay
T0039 M01,02,30 execution timing
T0046 Spindle speed/position switch timing
5.3.2 Counter address C(Defined by standard PLC Ladders)
Address Meaning
C0001 Rapid feedrate override - counting on MDI panel
C0002 Rapid feedrate override + counting on MDI panel
C0004 Feed - counting on MDI panel
C0005 Feed + counting on MDI panel
C0006 Spindle override – counting on MDI panel
C0007 Spindle override + counting on MDI panel
C0016 Manual feed – counting on MDI panel
C0017 Manual feed + counting on MDI panel
C0020 2 resetting counting of tool change unfinished alarm
5.3.3 Timer presetting address DT(Defined by standard PLC ladders)
Address Meaning
DT000 Time for original gear disabling during spindle automatic
gear changing (ms)
DT001 Delay time after the changed spindle gear is in position (ms)
DT002 Detection time for low pressure alarm (ms)
DT004 Permit time for tool changing (ms)
DT005 M command execution time (ms)
DT006 S command execution time (ms)
DT007 Delay time for tool post from CW to CCW output (ms)
DT008 Tool post lock signal detection time (ms)
DT009 Tool post CCW rotation lock time (ms)
DT010 Spindle braking delay output time (ms)
DT011 Spindle braking output time (ms)
Chapter 5 Diagnosis Message
445
Ⅲ Connection
Address Meaning
DT012 Spindle JOG time (ms)
DT013 Time for manual lubricating ON (0: time is not limited) (ms)
DT014 Chuck clamping command execution time (ms)
DT015 Chuck unclamping command execution time (ms)
DT016 Interval of automatic lubricating (ms) (can be modified
directly)
DT017 Time for automatic lubrication output (ms) (can be modified
directly)
To Next Page
Loading...
Need help?
General