TOMATECH AUTOMATION
Bit4 1: Do not detect software stroke limit；
0: Detect software stroke limit.
Bit3 1: Emergency stop inactive；
0: Emergency stop active；
Bit1 1: The software limit is valid after system is energized and before machine zero return
is
performed;
0: The software limit is invalid after system is energized and before machine zero return is
performed;
0 4 5 LT1n1
0 4 6 LT1n2
［Data type］ Word axis
［Data meaning］ LT1n1: Maximum stroke on positive direction; LT1n2: Maximum stroke
on
negative direction
［Data Unit］
Setting unit IS-B IS-C
Metric machine 0.001 mm 0.0001 mm
Inch 0.0001 inch 0.00001 inch
［Data range］ -99999999～99999999
Note: When bit 2 of parameter No. 001 set diameter programming, X axis is set by diameter system;
when bit 2 set
radius programming, X axis is set by radius system.
PLC parameter
D T 0 2 PEALMTIM
［Data meaning］ Under-pressure alarm detection time
［Data unit］ ms
［Data range］ 0～2147483647
Chapter 3 Parameters
403
Volume Ⅲ Connection
D T 2 1 PSANGNT
［Data meaning］ Chuck operation delay time after spindle stop;
［Data unit］ ms
［Data range］ 0～2147483647
3.2.5 Machine zero return
0 0 4 *** DECI ***
Bit5 1: Deceleration begins as DEC signal is connected to +24V in machine zero return
0: Deceleration begins as DEC signal is disconnected to +24V in machine zero return
0 0 5 PPD
Bit1 1: Relative and absolute coordinate set together for absolute setting and reference
return by
G50
0: Only absolute coordinate set for absolute setting and reference point by G50
To Next Page
Loading...